Filter
Top Products
22
ENGLISH
LISTENING TO A PROGRAM SOURCE
Select the desired input source.
1
• Each time the INPUT SELECTOR button on the
front panel is pressed, the input source changes as
follows;
TUNER
TAPE AUX VIDEO 1
(frequency displays.)
7-DIRECT
VIDEO 3 VIDEO 2
When selecting the 7 CH DIRECT
• “7-DIRECT” is displayed and the 7 or 6 separate analog
signals from the component connected to this input can
be controlled only by volume depending on the
surround back speaker setting.
• These analog signals (except front L/R channel)
cannot be recorded.
When AUX, VIDEO 1~3 is selected as an
input source
Select the digital or analog input
connected as desired.
2
• Each time this button is pressed, the corresponding
input is selected as follows ;
A(nalog) o(ptical) 1 o(ptical) 2 c(oaxial) 1
• To listen to a DTS, Dolby Digital or MPEG program
source in the 2-CH downmix mode, in the stereo
mode, the corresponding digital input should be
selected. (For details, refer to “Downmixing into 2
front channels” on page 30.)
Notes :
• When the selected optical or coaxial digital input is
not connected, the “DIGITAL” indicator flickers,
meaning no sound.
• The sound from the component connected to the
selected digital input can be heard regardless of the
selected input source.
DIGITAL INPUT
AM/FM MODE
Depending on the input digital signal format,
select the desired decoding mode.
3
Notes :
• Only when the digital input is selected as signal input for the input sources except TUNER, TAPE and 7 CH
DIRECT, the decoding mode can be selected.
• Noise may be generated at the beginning of playback and while searching during DTS playback in the IN-AUTO
mode. In this case, try playing in the IN-DTS mode.
• Each time this button is pressed, the decoding mode
changes as follows :
IN-AUTO : The input digital signal format(DTS, Dolby
Digital, MPEG or PCM(2 channel stereo),
etc.) used by the selected digital input
source is detected automatically to perform
the necessary decoding process for optimum
surround mode.
IN-DTS : The DTS signal processing is performed only
when DTS signals are input.
IN-PCM : The PCM signal processing is performed only
when PCM signals are input.
DECODING
TUNE MODE
or
INPUT SELECTOR
7 CH DIR.
TUNER
AUX
TAPE
VIDEO1
VIDEO2
VIDEO3
or
AUTO