Filter
Top Products
29
• Each time this button is pressed, the parameter changes and is displayed for several seconds as follows;
Panorama mode(“PANO”, default value: OFF)
This mode extends the front stereo image to include the surround speakers for an exciting “wraparound”
effect with side wall imaging. Select “OFF” or “ON”.
Center width control(“C-WID”, default value: 0)
This adjusts the center image so it may be heard only from the center speaker, only from the left/right
speakers as a phantom image, or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.
Dimension control(“DIMEN”, default value: 0)
This gradually adjusts the soundfield either towards the front or towards the rear. The control can be set
in 7 steps from -4 to +2.
• When selecting the Dolby Pro Logic II Music mode, you can adjust the various surround parameters for
optimum surround effect.
• You can also adjust the Dolby Pro Logic II Music parameters with using the buttons on the front panel.
(For details, refer to “SETTING UP THE SYSTEM ON FRONT PANEL” on page 43.)
Adjusting the Dolby Pro Logic II Music parameters
Press the PL II MUSIC PARAMETER button to select
the desired parameter.
1
PL II PARA.
ENGLISH
• If the parameter display disappears, start from the
step 1 again.
While displaying the desired parameter,
adjust it as desired.
2
Repeat the above steps 1 and 2 to adjust
other parameters.
3
ADJUST
UP(>), DOWN(<)