Filter
Top Products
40
ENGLISH
Select the desired menu or(and) change the
condition with the corresponding buttons.
4
Repeat the above steps 2~4 to change the
conditions on other menus.
5
When selecting the AUTO OSD
• Each time the ENTER button is pressed, the AUTO OSD mode is set to ON to turn on the current display or OFF
to turn it off.
• When the AUTO OSD mode is set to ON, the current status display overlays the program image on the monitor TV
and may interference with your movie enjoyment. In such a case, set it to OFF.
Notes:
• OSD function on this unit can display all the settings.
• According to your selections for the input source, input signal, decoding mode, surround mode, speaker settings,
etc., the conditions of each menu may differ.
• When adjusting the speaker distance or channel level, etc., use the CURSOR LEFT( ) and RIGHT( ) buttons.
• In OSD, the parenthesized passage means that it is changeable by pressing CURSOR LEFT(
) and RIGHT( )
buttons.
When selecting the CH LEVEL SETUP
• You can adjust the preset channel level in PRESET TRIM menu.
The adjusted is(are) memorized in preset channel level.
• You can adjust the current channel level in CH LEVEL SETUP mode.
The adjusted is(are) just memorized, not in preset channel level.
• If you press ENTER button on the remote control unit after adjusting the current channel level in CH LEVEL SETUP
menu, that setting is memorized in preset channel level. You can load it again by selecting PRESET CALL.
When selecting
PRESET TRIM menu
When selecting
CH LEVEL TRIM menu