Sherbourn Technologies PT-7010A Stereo Amplifier User Manual


 
30
Operation of the PT-7010A
using the Remote
Turning on the MAIN Zone
1) Press the remote’s MAIN button to make sure the
display is on the main display menu.
2) Press the 7010A device button to set the remote to
operate the PT-7010A. The display changes to show the
PT-7010A input selections.
3) Press PAGE to reach page 2, which shows the PRO
LOGIC-II, PARTY, STEREO, and the trims for center,
surrounds, and sub. On the right is ‘+’ (increase level) and
on the left is ‘-’ (decrease level).
4) The following buttons with fixed labels are also
programmed: Power, Volume Up, Volume Down, and
Mute. The number pad accesses the tuner presets directly,
and CH+/- steps through them. DIS is the +10 function,
and ENT is station enter. The MODE buttons either side
of the Joystick, allow you to select the different surround
modes.
Turning on ZONE 2
1) Press the remote’s MAIN button to make sure the
display is on the main display menu.
2) Press the ZONE 2 device button to set the remote to
operate the Zone 2 of the PT-7010A. The display changes
to show the PAGE 1 of the ZONE 2 input selections.
3) The hard buttons operate Zone 2 controls such as
Power, Volume, Mute, Tuner Controls, and Presets.
4) Press PAGE to reach page 2, which shows Zone 2 on/
off, Zone 1 on/off, and balance left/ right.
Note: Zone 2 must first be enabled using the OSD (see
page 37), or these controls will have no effect. Zone 2 is
disabled by default as it is shipped from the factory. When
enabled, Zone 2 can be turned on even if the Main Zone
is off. See page 37 for more Zone 2 details.
After pressing 7010A, you will enter PAGE 1 and PAGE 2 screens
for commanding the PT-7010A by remote. These functions allow
source selection and individual level control of specific speakers
as labeled.
After pressing ZONE2, you will enter PAGE 1 and PAGE 2
screens for commanding Zone 2 of the PT-7010A by remote.
These functions allow source selection as well as control of
turning on/off of both zones 1 & 2