Sherbourn Technologies PT-7010A Stereo Amplifier User Manual


 
10
PT-7010A Rear Panel Layout
1 Audio/Video Inputs
These audio, Component
Video, Composite-Video
and S-Video inputs
connect to the outputs of
your audio video
components. When these
inputs are selected, the
audio will be heard in
your system and the
video will be seen on the TV screen. VID2 can be used
for a second VCR.
2 Audio/Video Outputs
MAIN
Connects to the inputs of a TV monitor, where the video
of any selected input and the On Screen Display (OSD)
can be viewed. The audio connections allow you to listen
to any selected audio source through your
TV’s speakers.
VCR
Connects to the inputs of a VCR to allow
recording.
VID2/MON2
Connects to the input of a second VCR
for recording, or to a second TV. When
configured in the OSD for “VID2,” this output is muted
whenever the VID2 input is selected. This prevents
feedback; also there is no OSD then on this output. When
configured for “MON2,” the output is always active, the
same as the Main output.
Note: Analog audio signals are present at these L and R
outputs even if a digital input has been selected. The
output is a 2 channel down mix if the digital source has
more than 2 channels.
3 Component Video In
These inputs connect to the component-
video outputs of your DVD, SAT or other
video source (VID1) if they have this
advanced capability. When these inputs
are selected, the PT-7010A will
automatically route any video signals going into these jacks
to the component video outputs. Note that component
video provides the best picture compared to composite or
S-Video. The PT-7010A can also route HDTV signals.
4 Component Video Out
If your TV Monitor has component video
inputs, connect them to these outputs. If you
select DVD, SAT or VID1, then any video
signals going to the component inputs, will
pass through to your TV monitor. The PT-
7010A can also up convert any Composite Video or S-
Video signals from the other inputs to Component Video.
5 Infrared (IR) Inputs
These are used in custom installations to control the
Main Zone and Zone 2 from a remote location. The
input accepts 1/ 8" mono mini-jacks from standard
remote control IR equipment, such as those made
by Xantech and other companies. The remote sensors
can be in a different room, or in a preferred location
in your main room.
6 Triggers and Relay
The relay switch is normally open, and it
will close after a short delay, when selecting
a source. This can be used in installations
to trigger video screen deployment, or other
custom purposes. The OSD INPUTS menu