Sharp XL-HF302PH(T) Stereo System User Manual


 
E-21
Troubleshooting chart (continued)
Factory reset, clearing all memory
1
Press the ON/STAND-BY button to turn the power on.
2 Press FUNCTION button (main unit) repeatedly or
AUDIO/LINE (INPUT) button (remote control) to enter
Audio In mode.
3 Press button (main unit) once.
4 Press and hold button (main unit) until “RESET” appears.
Caution:
This operation will erase all data stored in memory includ-
ing clock, timer settings and tuner preset.
Before transporting the unit
Remove all devices connected to the unit. Then, set the
unit to the power stand-by mode. Carrying the unit with
other devices left connected or discs left inside might dam-
age the unit.
Care of discs
Discs are fairly resistant to damage. However mistracking
can occur due to accumulation of dirt on the surface.
Do not mark on the non-label side of the disc from which
signals are read.
Keep your discs away from direct sunlight, heat, and
excessive moisture.
Always hold the discs by the edges. Fingerprints, dirt,
or water on the CDs can cause noise or mistracking.
Clean it with a soft, dry cloth, wiping straight out from the
centre, along the radius.
Maintenance
Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted
soap solution, then with a dry cloth.
Caution:
Do not use chemicals for cleaning (petrol, paint thin-
ner, etc.). It may damage the cabinet.
Do not apply oil to the inside of the unit. It may cause
malfunctions.
Specications
As part of our policy of continuous improvement, SHARP
reserves the right to make design and specication chang-
es for product improvement without prior notice. The per-
formance specication gures indicated are nominal val-
ues of production units. There may be some deviations
from these values in individual units.
General
Power source AC 220 - 240 V ~ 50/60 Hz
Power
consumption
Power on: 52 W
Power stand-by: 0.4 W (*)
Dimensions Width: 215 mm (8 - 1/2”)
Height: 96 mm (3 - 4/5”)
Depth: 335 mm (13 - 1/5”)
Weight 2.6 kg (5.7 lbs.)
Frequency band 2.400GHz - 2.480GHz
Compatible
Bluetooth Prole
A2DP (Advanced Audio Distribution
Prole), AVRCP (Audio/Video
Remote Control Prole)
Bluetooth 2.1 +EDR
( * ) This power consumption value is obtained when the demon-
stration mode is cancelled in the power stand-by mode. Re-
fer to page 4 to cancel the demonstration mode.
Amplier
Output power PMPO: 200 W
MPO: 100 W (50 W + 50 W)
(10% T.H.D.)
RMS: 100 W (50 W + 50 W)
(10% T.H.D.)
RMS: 66 W (33 W + 33 W)
(1% T.H.D.)
Output terminals Speakers: 4 ohms
20Hz - 20kHz
Subwoofer Pre-out (audio signal):
200 mV/10 k ohms at 70 Hz
Headphones: 16 - 50 ohms
(recommended: 32 ohms)
Input terminals Audio In (audio signal):
500 mV/47 k ohms
Line in (Analogue input):
500 mV/47 k ohms