Sharp MD-R2 MiniDisc Player User Manual


 
Error messages Meaning Remedy
BATT EMPTY
The battery has run down. Charge the rechargeable battery or
replace the alkaline batteries (or use
the AC adaptor for power).
BLANK DISC
Nothing is recorded. Replace the disc with a recorded
disc.
Can’t COPY
No copy can be made because of
the SCMS copyright system.
Record using the analog cable.
Can’t EDIT
A track cannot be edited. Change the stop position of the
track and then try editing it.
Can’t REC
Recording cannot be performed
correctly due to vibration or shock
in the unit.
Re-record or replace it with another
recordable disc.
Can’t WRITE Editing is impossible. Check the number of tracks.
DEFECT
The disc is scratched. If the sound you hear is not correct,
try recording again.
Replace the disc with another
recordable disc.
Din UNLOCK Poor connection of the digital cable. Connect the digital cable securely.
DISC ERROR The disc is damaged. Reload the disc or replace it.
DISC FULL
The disc is out of recording space. Replace it with another recordable
disc.
HOLD
The unit is in the safety mode. Return the HOLD switch to its
original position.
LOCKED
LOCK ERROR
The EJECT lever was moved
during recording or editing.
Turn off the power and remove the
MiniDisc.
NO DISC A disc has not been loaded. Load a disc.
PB DISC
PROTECTED
The disc is write protected.
You tried to record on a playback-
only disc.
Move the write protection knob
back to its original position.
Replace it with a recordable disc.
POWER ?
Improper power is being supplied. Use one of the specified power
sources.
SORRY
Since a track number is currently
being located or written to, the unit
cannot accept your command.
Wait and then try the operation
again.
SYSTEM ERR
The unit is malfunctioning and will
require service.
For service, contact your local
Sharp authorized service center.
TEMP OVER
The temperature is too high. Turn off the power, and wait for the
unit to cool.
TOC ERROR
A large portion of the disc has been
damaged.
Replace it with another recorded
disc.
TOC FULL
There is no space left for recording
character information (track names,
disc names, etc.).
Replace it with another recordable
disc.
Tr. Protect
The track has been protected from
being erased.
Edit the track with the device on
which it was recorded.
U TOC ERROR
A large portion of the disc has been
damaged.
There is an error in the recorded
signal.
Replace it with another recorded
disc.
Erase all of the signal errors, and
then try recording again.
? DISC
A disc which contains data other
than music was played.
There is an error in the signal from
the disc.
A disc which contains non-music
data cannot be played.
Replace it with another recorded
disc.
ERROR MESSAGES
39
MD-MS702