Sharp MD-R2 MiniDisc Player User Manual


 
To check the remaining
disc time
While recording, you can check the
remaining time available on the disc.
Press the DISPLAY button while recording
or while in the recording pause mode.
When the DISPLAY button is pressed
again, the unit will return to the initial
display.
Note:
The display of the remaining disc time
may vary slightly from the actual
remaining time. (Page 38)
To create your own track
numbers while recording
You can create your own track numbers at
special points in a recording, so that these
points can easily be found later.
At any point where you want to create a
track number while recording, press the
REC button on the main unit or the BASS
button on the remote control unit.
The track number will be written on the
disc and the recording will continue
uninterrupted.
Double time recording in
monaural mode
When recording in the monaural long-play
mode, recordings will be approximately
twice as long as the recording time avail-
able for a stereo recording. The monaural
long-play mode is very useful for recording
conferences or lectures.
Press the MODE/INS button while the
recording is paused.
Each time this button is pressed, the
display will switch between the stereo
mode and the monaural long-play
mode.
Notes:
If input is from a stereo source, the
sounds from the left and right channels
will be combined.
Although the monitor sound you hear in
the headphones while recording is in
stereo, recording will be monaural.
MiniDiscs recorded in the monaural
long-play mode cannot be played on
other MD players.
When a recording is made in the
monaural long-play mode, you will be
able to play back the MiniDisc twice as
fast as the normal playback speed.
(Page 24)
When the unit is stopped after a record-
ing has been made in the monaural
long-play mode, the recording mode
will return to the stereo mode automat-
ically.
Remaining recordable time
Lights up while in the
monaural long-play mode.
17
MD-MS702