Sharp MD-R2 MiniDisc Player User Manual


 
To interrupt playback:
Press the button during playback.
To resume playback, press the
button again.
To stop playback:
Press the /:OFF button.
When you press the button to re-
sume playback, it will start at the point
on the disc where playback was halted
(Resume function). However, if the
MiniDisc is removed and reinserted,
playback will start from the first track.
To turn off the power:
Press the /:OFF button while in the stop
mode.
If the unit is not operated for at least 2
minutes while in the stop mode, the
power will be turned off automatically.
To remove the MiniDisc:
Turn off the power and move the EJECT
lever in the direction indicated by the
arrow.
When using the unit with just the
batteries in the battery case:
The auto-play function will not work.
To start playback, hold down the
button for about 1 second.
Even if a MiniDisc is replaced while
the power is turned off, the random
or repeat play settings will remain
unchanged in memory.
Precautions when making connec-
tions:
Do not use any remote control unit,
except for the one included with this
unit.
Insert each plug securely, all the way
in.
Be sure to hold the plug when
removing it. If you pull on the cord, it
may break, or the unit may malfunc-
tion.
Interrupted sound:
This product is designed to eliminate
interruptions in the sound which can
be caused by vibrations. However, if
the unit is continuously exposed to
vibrations or mechanical shock, the
sound may be interrupted momen-
tarily.
When the sound is distorted:
If the volume is too high while the
bass is being emphasized, the sound
may be distorted, depending on the
music on the track. If this happens,
decrease the bass level or lower the
volume level.
If the volume is increased to “VOL
26" or higher, the bass level will be
adjusted automatically.
(This is done to reduce the distortion
in the sound.)
Cautions:
When the unit is not to be used im-
mediately after a MiniDisc has been
inserted, or when you plan to carry
the unit, turn off the power or cancel
the auto-play function. Otherwise,
the auto-play function will be ac-
tivated and the batteries will run
down.
Since the main unit and the AC
adaptor can heat up during use, you
should avoid allowing the unit to be
in direct contact with your skin for
any length of time.
When using the unit with a car
adaptor:
When switching off the ignition
during playback, the power to this
unit will also be turned off. When the
ignition is switched on, playback will
start from the beginning of the track
where playback was halted (Resume
auto-play function). However, the
power to the unit may not be turned
off when the ignition is turned off,
depending on the type of car.
22
MD-MS702