Filter
Top Products
MD-MT877/MD-MT877C
– 18 –
Performance mode =Normal
Playback volume =28
LINE REC volume =30
Microphone REC volume =20
Resume setting =Cancellation
: To the test mode stop ([Test mode menu])
Volume+
Volume -
: Version indication 2 seconds
EEPROM version
Test Mode Start · Completion methool
All the lighting
T E S T
• Starting method of the test mode
When the unit is in the stand-by state (with no display), the test mode is started by performing
the following operation using the remote control.
Press the [PLAY] button while pressing the [PLAY-MODE] button, and release the [PLAY-MODE] button
while keeping the [PLAY] button pressed, and press the [VOLUME–] button.
: LCD all the lighting two seconds
Destination
Program version
• How to cancel the test mode
T E S T
B Y E
B Y E O K
POWER OFF
: Test mode stop
: [OK] or [NG]
Check the microcomputer RAM and EEPROM with
the contents of the preliminary adjustment.
Pickup position initialisation
EEPROM contents renewal
STOP
Indication after the start :
(During the spare style automatic adjustment)
(During the focus balance adjustment)
(During the adjustment that ATT is automatic)
Normality completion
(Adjustment completion)
(Continuance is regenerating)
It confirms that an address proceeds
PLAY
PLAY
A U T O 1
Do the following when replacing the mechanism, the pickup, the
EEPROM (IC402), the LSI(IC201) or the main PWB unit.
A D J . O K
A T 2
A T 1
If you replaced EEPROM, set the EEPROM valume to the final version.
The indication of RAMDOM
A P # # # #
Indication disappears
All the supply of the power supply is turned off
B Y E O K
PLAY
STOP is pushed
Remote controller P-MODE button
A D J . O K
Enter the test mode, move the pickup to the most internal periphery and execute AUTO1.
(Use the disc of MMD-213A.)
The indication of "TEST"
A D J . O K
AUTO2 It is made to carry it out
Move the pickup to the most internal periphery and press the BASS button
(Fast Forward Button)
PLAY
STOP is pushed
Normality completion
(In such cases as the battery)