Sharp MD-M1H Stereo System User Manual


 
47
When an error message is displayed, proceed as follows:
Error messages
BLANK MD
CAN’T EDIT
CAN’T REC
CD NO DISC
DISC FULL
FOCUS ERR
MD ERR
MD NO DISC
MECHA ERR*
(*:Number or
symbol)
NAME FULL
NOT AUDIO
PLAY MD
PROTECTED
READ ERR
TEMP OVER
TOC ERR*
(*:Number or
symbol)
TOC FULL*
(*:Number or
symbol)
TOC W ERR
U TOC ERR*
(*:Number or
symbol)
U TOC ERR W
? DISC
00:00
Remedy
Replace it with another disc.
Change the stop position of the track and
then try editing it.
Re-record or replace the MiniDisc.
Replace it with another disc.
Load a CD.
Reload the CD.
Replace the disc with another recordable
disc.
Reload the MiniDisc.
Contact the shop where you purchased the
unit.
Load a MiniDisc.
Reload the MiniDisc.
Set this unit to the stand-by mode and press
the MD EJECT button.
Shorten the disc or track name.
Select another track.
Replace the disc.
Replace it with another recordable disc.
Move the write protection tab back to its
original position.
Reload the disc or replace it.
Set this unit to the stand-by mode and wait
for a while.
Replace it with another disc.
Replace it with another recordable disc.
Contact the shop where you purchased the
unit.
Replace it with another disc.
Erase the disc and try recording again.
Set this unit to the stand-by mode and try to
write the TOC again. (Remove any source
of shock or vibration whilst writing.)
Replace it with another disc.
Replace the disc with another recordable
disc.
Meaning
Nothing is recorded.
A track cannot be edited.
Recording cannot be performed correctly
due to vibration or shock in the unit.
Timer recording is impossible or there is no
available space on the MD.
A CD has not been loaded.
The disc data cannot be read.
The disc is out of recording space.
A disc has not been loaded.
The disc data cannot be read.
Trouble is found.
A MiniDisc has not been loaded.
The disc data cannot be read.
There is a mechanical problem and the disc
is not working properly.
The number of characters for the disc name
or track name exceeds 40.
The data recorded on this disc is not audio
data.
You tried to record on a playback-only disc.
The disc is write protected.
The disc is damaged.
A TOC is not written on the MD or there is
something wrong with data.
The temperature is too high.
The disc is damaged.
TOC information cannot be read.
MD not specified.
There is no space left for recording charac-
ter information (track names, disc names,
etc.).
Recording is impossible.
TOC information recorded on the MD does
not match the MD specifications or it can-
not be read.
The TOC information could not be created
properly due to a mechanical shock or to
scratches on the disc.
The data contains an error.
Music is not being recorded.
ERROR MESSAGES