Sharp MD-M1H Stereo System User Manual


 
41
Sleep timer setting
Timer playback
(record) setting
Timer playback
(record) start
1 minute - 2 hours
Desired time
Sleep operation will
automatically stop.
End time
Caution:
In the following cases, the timer recording function
will not work.
When a MiniDisc has not been inserted.
When a playback-only MiniDisc is inserted.
When the MiniDisc you inserted is protected
against accidental erasure.
When there is no recording space left on the Mini-
Disc you have inserted (when the “TOC FULL
” or “DISC FULL” messages appear).
Sleep operation
The radio, compact disc and MiniDisc can all be
turned off automatically.
TIMER
SLEEP
/
ENTER
(Remote control operation)
1 Play the desired sound source.
2 Press the SLEEP button.
REC
SLEEP
SLEEP
If you do not need to change the time, the unit
will enter the sleep mode automatically.
3 Within 5 seconds, press the ENTER button.
REC
SLEEP
4 Press the or button to adjust the time.
(Maximum: 2 hours - Minimum: 1 minute)
The amount of sleep time can also be changed
during the sleep operation.
REC
SLEEP
5 Press the ENTER button.
SLEEP
DISC TOC
TRACK
MEMORY
RANDOM
TOTAL
REMAIN
REC
SLEEP
6 The unit will enter the stand-by mode automati-
cally after the preset sleep time has elapsed.
To cancel the sleep operation:
Press the ON/STAND-BY button to enter the stand-
by mode.
The sleep operation can also be cancelled as fol-
lows if you can not set the unit to the stand-by mode
during recording.
Press the SLEEP button.
“SLEEP” will flash.
Within 5 seconds, press the SLEEP button again.
The sleep operation will be cancelled.
(“SLEEP” will go out.)
Notes:
Once the sleep time is set, it will remain the same
duration until the setting is changed.
The sleep functions of this unit cannot be used
to control equipment connected to this unit. You
must use the sleep functions of the other equip-
ment, if it has them.
Simultaneous sleep and timer op-
eration
To use sleep and timer playback in combi-
nation:
Perform steps 1 - 9 on page 39 “Timer playback”.
Perform steps 1 - 5 of the “Sleep operation” on
this page.
To use sleep and timer recording in com-
bination:
Perform steps 1 - 9 on page 40 “Timer record-
ing”.
Perform steps 1 - 5 of the “Sleep operation” on
this page.
(Continued)