Sharp MD-M1H Stereo System User Manual


 
46
(Continued)
Symptom
A recording cannot be made.
Even though a disc has been
loaded, “MD NO DISC” or “READ
ERR” is displayed.
Playback sounds are skipped.
Possible cause
Is the MiniDisc protected against
accidental erasure?
Did you try to make recording on a
play-back only MiniDisc?
Can you see the “DISC FULL” or
“TOC FULL
” message in the dis-
play?
(
:number or symbol)
The disc is very dirty.
Is the unit located near excessive
vibrations?
Has condensation formed inside the
unit?
Remedy
Slide the accidental erase pre-
vention tab back to its original
position.
Replace it with a recordable
disc.
Put in another recordable disc
with recording space on it.
Clean the disc.
Place the unit on a firm, level
surface free from vibration.
Remove the disc and leave the
power turned on. The unit
should function properly in
about 1 hour.
MD recording and playback
Symptom
Radios make unusual noise con-
secutively.
The preset channel cannot be re-
called.
Possible cause
The unit is placed near the TV or
computer.
The aerial direction is not placed
properly.
Did you erase the programmed sta-
tion?
Remedy
When the unit receives a radio
broadcast near a TV set, a com-
puter or a word-processor,it may
pick up noise. If this hap-
pens,try to move the unit from
the place where the noise is
picked up.
Correct the aerial direction.
Preset the channel again.
Redo programming.
Radio reception
Symptom
The remote control does not func-
tion or does not operate properly.
The power cannot be turned on
from the remote control.
Possible cause
The batteries (polarity) are not in-
serted properly.
The batteries inside the remote con-
trol are dead.
The remote control is operated from
an incorrect distance or angle.
Is the AC power lead plugged in?
Remedy
Insert properly.
Replace the batteries.
Operate it within a range of 0.2
m (8") to 6 m (20’) and within
an angle of 15 ° to either side of
centre.
Connect the AC power lead.
Remote control
CD Playback
Possible cause
The disc is loaded up-side down.
The disc is very dirty.
The disc which does not satisfy the
standards.
Is the unit located near excessive
vibrations?
Has condensation formed inside the
unit?
Remedy
Load the disc with the correct
side up.
Clean the disc.
Load the correct disc.
Place the unit on a firm, level
surface free from vibration.
Remove the disc and leave the
power turned on. The unit
should function properly in
about 1 hour.
Symptom
Even though a disc has been
loaded, “CD NO DISC” or “ERR”
is displayed.
Playback stops in the middle of a
track, or playback is not performed
properly.
Playback sounds are skipped.