Filter
Top Products
9
1
7
6
5
4
3
2
1
9
2011 January 27
HT-SB600
E-9
Caution:
● Be very careful to prevent the speaker [ 4.41 lbs. (2.0 kg)]
from falling when mounting on the wall.
● Before mounting, check the wall strength. (Do not put
on the veneer plaster or whitewashed wall. The speaker
may fall.) If unsure, consult a qualified service
technician.
● Mounting screws are not supplied. Use appropriate
ones.
● Check all wall mount angle screws for looseness.
● Select a good location. If not, accidents may occur or
the speaker may get damaged.
● SHARP is not responsible for accidents resulting
from improper installation.
SHARP designed the speakers so you may hang them on
the wall. Use proper screws (not supplied). See below for
size and type.
Note:
Make sure all screws are fully tightened. (screws are not
supplied)
Safety wires (not supplied) are useful to prevent the
speaker from falling off the table.
Loop the safety wires (not supplied) into each hole as
shown and tie the safety wires to the LCD TV stand.
Speaker preparation
To mount the speaker on the wall
1 Fix the pattern paper to the wall in horizontal
position as below.
2 Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
3 Fix a wall mount plug (not supplied) into the hole
using a hammer, until it is flush with the wall
surface.
Driving screws
1/8" (3.2 mm)
3/8" (9 mm)
7/8" (Min. 22 mm)
3/16"
(5 mm)
Fixing wall mount angle
(Horizontal position)
Pattern paper
Wall surface
29 mm
44 mm
509 mm
44 mm
29 mm
Wall surface
3/8" (8-9 mm)
1-1/4" (32 mm)
Wall surface
3/8" (8-9 mm)
1-1/4" (32 mm)
4 Screw the wall mount angle to the wall as shown in
the illustration. (Total screw is 8 pieces)
1 Align the wall mount slot at the speaker to the wall
mount angle.
2 Slot the speaker into the wall mount angle.
3 Fix them securely.
Wall surface
Wall mount angle
Wall mount
angle
Wall
surface
Wall surface
Wall
mount
angle
(screws x 4)
(screws x 4)
Installing the speaker
Wall surface
Falling prevention