Filter
Top Products
p
Disc Playback
Before Starting Playback
Setting the Remote Control
Code
• 3 types of remote control codes operate this Player:
RC-1, RC-2 and RC-3. If you operate this Player
by remote control along with another SHARP
Blu-ray Disc Player or DVD Player placed next to it
simultaneously, switching the remote control code
(both the Player and remote control) to one of the
signals (RC-1, RC-2 or RC-3) will let you operate
only with this Player.
• Make sure to set the Player and remote control to
the same remote code. You can not operate the
Player if they are not set to the same code.
Setting the Remote Control
Code of the Remote
Example: Setting the code to “RC-3”.
Press and hold 3 fi rst and then
POWER on the remote control
together for more than 5 seconds.
Press POWER to turn off the player.
1
2
Operating a SHARP TV
Using the Remote Control
The Universal Remote Control may operate the
basic functions of the SHARP TV.
TV function control
• TV Power: POWER
• TV Channel up/down: CH r / s
• TV Volume up/down: VOL e/f
• TV-AV Selector: INPUT
Setting the Remote Control
Code of the Player
Point the remote control at the
player, then press and hold the
DISPLAY button.
3
Approx. 2 sec. later
Approx. 3 sec. later
POWER
If remote control does not work
First, press Power to turn on the player.
Press POWER on the remote control and check
the front panel display (RC-1, RC-2 or RC-3).
Set the remote control code according to the
display and press POWER to see if you can
turn on/off the Player.
Example: Change “RC-1” to “RC-3”.
Remote control sensor
The display on the player changes
as shown below, and the player will
be set to the same number as the
remote control.
21
BD-HP20U_en_d.indd 21BD-HP20U_en_d.indd 21 2007/09/11 13:44:282007/09/11 13:44:28