Filter
Top Products
18
Selecting the standard display – dISP
Via the “dISP” menu, you can select one of the following
standard displays:
The selected standard display is shown
y after switch-on,
y after the parameters have been displayed for 15 seconds
in display mode.
Note:
In order that the transmitter battery status can be
displayed on the “BAt.tr” standard display, this
functionality must be supported by the transmitter
used (see “Suitable transmitters” on page 4).
Loading the factory-preset default settings
– rESEt
Via the “rESEt” menu, you can load the factory-preset
default settings. After the reset, the standard display is
shown on the LC display panel.
Caution:
The frequencies in the channel bank “U” (variable bank)
are also reset.
Activating/deactivating the lock mode – Loc
Via the “Loc” menu, you can activate (Loc.on) or deactivate
(Loc.oFF) the lock mode of the receiver.
Exiting the selection mode and returning to
the standard display – ESc
Via the “ESc” menu, you can exit the selection mode and
return to the standard display.
When in the selection or setting mode, briefly pressing the
ON/OFF button » will cancel your entry (ESC function) and
return you to the standard display without saving any
changes.
Channel Frequency Battery status
“CHAn”“FrEq”“BAt.tr”
Headphone volume: 20
Squelch threshold: 10
Standard display: frequency
Current receiving channel: F.01
Automatic switch-on/off
via camcorder: activated
Lock mode: deactivated