Filter
Top Products
Using the devices
18
If you cannot establish a transmission link between transmitter and receiver:
̈ Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel.
̈ If necessary, read the chapter “If a problem occurs ...” on page 30.
Switching the devices on/off
EM 500 receiver
To switch the receiver on:
To switch the receiver to standby mode:
̈ If necessary, deactivate the lock mode (see page 22).
To completely switch the receiver off:
̈ Disconnect the receiver from the mains by unplugging the mains unit from the wall
socket.
It is vital to observe the following notes:
̈ Make sure that the desired frequencies are listed in the enclosed frequency
information sheet.
̈ Make sure that the desired frequencies are approved and legal in your country
and, if necessary, apply for an operating license.
2
00
KM500
e
w500 G3
E
MHz
¶
̈ Briefly press the STANDBY button ¶.
The receiver switches on and the “Receiver Parameters” standard display
appears.
̈ Keep the STANDBY button ¶ pressed until “OFF” appears on the display panel.
When in the operating menu, pressing the STANDBY button ¶ will cancel your entry
(ESC function) and return you to the current standard display.