Filter
Top Products
61
11. Rotate the Tuning/Select control until the 'Volume:' option is highlighted
on the display and press the control if you wish to change it. The radio
uses the saved volume setting for each alarm when it sounds.
Rotate the control to set the required volume and then press the control
to confi rm the setting.
12. In order to store the alarm settings rotate the Tuning/Select control
until 'Save' is highlighted. Press the control to store the alarm settings.
Your radio will show 'Alarm saved' and will then go back to the list of
alarms with the new alarm setting shown in the display.
If you decide not to save the settings, press the Back button. The
display will show 'Save changes' with a YES or NO option. Rotate
the Tuning/Select control to choose 'NO' and then press the control.
'Alarm not saved' will show on the display.
Active alarms are shown using small alarm indicators at the bottom
of the playing displays and on the clock display when in stand-by.
Note: If you make a mistake at any point while setting the alarms, use the
Back button to go back to the previous screen.
When the alarm sounds
The buzzer or radio alarm will sound at the selected times for up to 60
minutes unless cancelled. The volume used for the alarm will be as specifi ed
during the alarm setting procedure. If the radio cannot connect to the
specifi ed radio station, the buzzer alarm will be used instead.
To cancel an alarm, press the On/Off button to return to stand-by mode.
The alarm icon will fl ash at the bottom of the playing mode displays, and
the radio will automatically switch back to stand-by mode when the 60
minutes have elapsed.
Note: If the radio is switched on because of an alarm you can still control
basic functions such as volume and selecting presets. You cannot perform
operations which involve the Select control since this also acts as the
Snooze button (see page 62).
11-12