Filter
Top Products
59
Setting the alarm clock
Your radio has two separate alarms which can be set to wake you to either
the radio or a buzzer alarm. In the event of a power interruption your radio
has built in memory that will retain your alarm settings.
Ensure that the time is set correctly before setting the alarms.
IMPORTANT: Your radio must be powered from the mains supply in
order for the clock to run so that the alarms will operate. You cannot
use the alarms if the radio is only running from batteries.
1. With your radio switched on, press the Menu button to access the
menu for the current mode. Rotate the Tuning/Select control until
'Main menu' is highlighted on the display. Press the control to enter
the main menu.
2. Rotate the Tuning/Select control until 'Alarms' is selected on the
display. Press the control to see the current alarm settings. If no change
is required, press the Menu or Back buttons to exit.
3. Rotate the Tuning/Select control until the desired alarm (1 or 2) is
highlighted on the display. Press the control to enter alarm setup.
4. Rotate the Tuning/Select control until 'Time' is highlighted on the
display. Press the control to adjust the alarm time.
5. Rotate the Tuning/Select control to choose the alarm hour. Press the
control to confi rm the setting.
6. Rotate the Tuning/Select control to choose the alarm minute. Press
the control to confi rm the setting. The display will then return to the
alarm setting menu.
If the radio has been set to use a 12 hour clock format, there will also
be an option here for setting AM or PM for the alarm time.
1-6
1