Filter
Top Products
35
Set up UPnP access on a Windows PC - cont.
4. Rotate the Tuning/Select control until 'Shared media' is highlighted
and press the control to select. The sound system will scan for all
available UPnP servers. It may take a few seconds for the radio to
complete its scan. The radio will display '<Empty>' if no UPnP servers
are found.
5. After scanning, select your UPnP server using the Tuning/Select
control. If you are using WMP 11 as the server, your sound system will
then normally display 'Unauthorised - Select to retry' at this stage.
6. Your PC may prompt you that there has been a connection to your
UPnP server. Whether prompted or not, in order that the sound system
may access the music files, you will need to click the
'Library' tab in
WMP 11 and select the 'Media Sharing…' item to open the 'Media
Sharing' window. Make sure the box 'Share my media to:' is ticked.
7. In the 'Media Sharing' window, the sound system will be listed as an
unknown device. Click on the unknown device shown to select it, then
click the 'Allow' button and then click 'OK'.
Note: If you are using Microsoft Windows' firewall software, this should
be correctly configured by WMP 11. If you are using third party firewall
software you may need to manually configure it to allow your unit
and WMP 11 to communicate (see the 'Troubleshooting' section on
page 89).
8. On the sound system, select the named server again using the
Tuning/Select control. If WMP 11 is now able to communicate with
your sound system you will be presented with some media selection
options on the display.
Allowing a device to connect to Windows Media Player 11
4-8