Filter
Top Products
If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri)
18
Configuration .
Manual network configuration - cont.
The three controls on the right-hand side of the screen have special functions. You can quickly access
these by pressing the Info button and then use the Tuning/Select control as needed:
select ' ' to erase a character just entered (long press to clear); Info again to continue
select '
' when the complete encryption key has been entered
select '
' to cancel and go back to the SSID settings screen
Once the key is entered the sound system should connect to your network. Please skip to step 11.
9. WPA and WPA2 are similar, although WPA2 offers a higher level of security. Whichever you selected
in step 7, you then have to specify the variant used. They are TKIP (Temporal Key Integrity Protocol)
and AES (Advanced Encryption Standard). As previously, the setting should match that used by your
router. Some routers allow both to be specified, and the router will use whichever variant is supported
by the connected device. AES is regarded as the more secure option if it is available.
10. The sound system will then require you to enter the encryption key. This must be a string of between
8 and 63 characters and must be identical to the key which has been entered into your router.
Note
- the encryption key is sensitive to the use of upper and lower case letters and symbols. Take care to
enter the key exactly, or the radio will not be able to connect to your router.
The three controls on the right-hand side of the screen have special functions. You can quickly access
these by pressing the Info button and then use the Tuning/Select control as needed:
select ' ' to erase a character just entered (long press to clear); Info again to continue
select '
' when the complete encryption key has been entered
select '
' to cancel and go back to the TKIP / AES options screen
Once the key is entered the sound system should connect to the network.
11. While the sound system is trying to connect to the network, it will display
'Processing...' when checking
the encryption key (if using the WiFi connection) and then 'Connecting...'. If the connection is made
successfully, the sound system will return to the Network settings menu. If the unit cannot connect,
then it will display a 'Failed to connect' message and will return to the SSID entry screen (step 6).
Once connected, the network settings are stored in the sound system. The settings are retained when
the sound system is disconnected from the mains.
You may now use the
Back and Mode buttons to access the functions of your sound system.