Filter
Top Products
16
INSTALLATION
¸ There is no router device in your home. You need to purchase a new router device to
upgrade your home network.
2. No extra dial-up program is executed in my computer, but I set a fixed IP address in my
computer.
¸ If the IP address is provided by your ISP supplier, there is probably no DHCP service in
your home network. You need to buy a new router device.
If the IP address is a virtual IP, such as 192.168.xxx.xxx, you should have a router
device. Therefore, the IP Radio device will function with your home network.
3. No extra dial-up program is executed in my computer, and I set the dynamic IP address in
my computer.
¸ There is a wireless router device in your home, the IP Radio device will be able to
operate with your home network.
Moreover, the IP radio allows to play the music loaded in your PC, this one being connected
to the same router.
2.1.2. Configuration as a Wireless Client
There are three network configuration modes available for the IP Radio device: simple wireless
client, wired client, or wireless access point (AP).
The factory default mode is the client mode. If an Ethernet cable is available, the device will
automatically select a suitable client mode to operate. Users can also manually change the
network configuration settings via the Setup menu "Setup/Advanced Setup/Configure
Network".
If you have a 802.11b/g wireless network in your home, this mode is the most straightforward
means of connecting the IP Radio device to the existing network.
Simply power the device, without connecting an Ethernet cable, and the device will
automatically switch to the wireless client mode and detect all available wireless APs (Access
Points). The first time the device is set to the wireless client mode, you need to determine
which AP to connect to and enter the encryption key. Once the settings have been established,
the device will remember the settings and attempt to connect to the designated AP when it is
switched on. However, if you encounter any difficulty in connecting to the designated AP, the
device will display the AP list for you to configure the device once again.