Filter
Top Products
Installation
30 Lightstyle™ Series LS-100d Installation/Operation Manual
PRE
L
IMINAR
Y
3.6
Turning on the Power
1. Turn on your source components.
2. Turn on the main power switch at the rear of the DHD Controller.
3. Press the ON button on the remote control (or the ON/STANDBY ( ) button on
DHD Controller front panel) to turn on the system. The vacuum fluorescent display on
the DHD Controller front panel briefly displays “Initializing System,” followed by
“Starting LS-100d.” On the projector, the POWER LED rapidly flashes green to
indicate that it is warming up.
4. When the projector is ready for use, the POWER LED lights solid green. On the DHD
Controller, the fluorescent display indicates the active source, input resolution/frame
rate and aspect ratio/screen; for example:
HDMI 1
16:9/1 1080i/60
Current
Source
Aspect Ratio/Screen
Input Resolution/Frame Rate
LS-100d
1080p/60