Filter
Top Products
Installation
14 Lightstyle™ Series LS-100d Installation/Operation Manual
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the LS-100d installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1
Choose a location for the projector 15
2
Mount the projector 18
3
Connect the DHD Controller to the projector 19
4
Connect signal sources to the DHD Controller 21
5
Connect other external equipment to DHD Controller
(optional):
• Audio processor or secondary display device
• Automation/control system (RS-232)
• 12-volt trigger-activated equipment
• External IR repeater
• Network hub, router or gateway (Ethernet)
27
6
Connect projector and DHD Controller to AC power and
power up
29
7
Adjust lens focus 31
8
Select the proper picture orientation 31
9
Use the Image Alignment controls to fine-tune image
geometry
32
10
Display calibration: adjust the following for each input and
display mode (resolution and frame rate); save settings
when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance
37