Filter
Top Products
27
From initial settings to recording
If you don’t hear demo project
Review the following steps to try to resolve it.
I did not see any meters move in Guitar Tracks or hear any sound
The most common cause of this is if the playback device is not set correctly.
In most cases, you can correct this by following these steps:
• On the Options menu, click Audio to open the Audio Options dialog.
• Make sure the driver mode is set to “ASIO”
• Make sure you have “VS-20” selected for both playback and recording devices.
If you do not see an option for VS-20, check the settings described in “Audio Driver Settings” (p. 24).
I can see meters moving in Guitar Tracks, but I don't hear anything
• Make sure the “Output Level” on the VS-20 Hardware is turned up
• Make sure the “DAW Output” on the VS-20 Hardware is also turned up
Audio starts to play, but I get a message that says DROPOUT or AUDIO STOPPED either in a dialog or
across the bottom of the screen
A dropout is a symptom of audio hardware when it is unable to pass audio data fast enough. There are a few things
that may alleviate this:
• Check the settings described in “Setting up Audio Devices” (p. 24)
• Ensure nothing else is trying to use the sound device at the same time. Guitar Tracks will perform best when there
are no other software applications attempting to use the sound device, such as web browsers, video players, instant
messaging clients and other sound applications.
VS-20_e.book 27 ページ ２０１０年１月１８日 月曜日 午前９時８分