Filter
Top Products
18
Panel Descriptions
fig.front01.eps
1. USB connector
Use a USB cable to connect the V-STUDIO 20 hardware
to a personal computer.
2. OUTPUT L and R (RCA pin output jack)
Analog audio signal output jacks. The effect sound and
the signal from your computer are mixed and output
here.
3. Footswitch jack
You can use the foot switch (sold separately) to control
playback or recording on the V-STUDIO from your
computer.
For more information about footswitch, see
“Connecting footswitches (optional)” (p. 23).
4. EXP PEDAL jack
Connect an expression pedal (sold separately).
The expression pedal can be used to control the
volume, or as a wah effect pedal. See
Connecting
footswitches (optional) (p. 23).
5. Headphone output
This output delivers the same signal as the MAIN
output. To adjust the headphone volume, use the
[Output Level] knob.
fig.front01.eps
1. GUITAR/BASS (Hi-Z)
This is an input jack for connecting an electric guitar,
bass, or Hi-Z microphone.
2. LINE L/R
These input jacks for connecting line-level analog
audio signals, such as an Synth, mp3 player, or other
line-level devices.
3. Security slot ( )
988
Connect a commercially available anti-theft security
cable here.
http://www.kensington.com/
4. MIC 2 (XLR balanced input)
This is an analog audio signal input jack that supports
XLR balanced input.
* The VS-20 Hardware can supply phantom power.
If you've connected a condenser mic that requires
phantom power, start up the editor, click System Settings,
and turn on phantom power.
922 modified
Input/output component
Side panel (Left)
12 345
Side panel (Right)
1234
This instrument is equipped with
balanced (XLR) type jacks. Wiring
diagrams for these jacks are shown
below. Make connections after first
checking the wiring diagrams of other equipment
you intend to connect.
VS-20_e.book 18 ページ ２０１０年１月１８日 月曜日 午前９時８分