Filter
Top Products
If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri)
76
Clock and Alarms .
Setting the alarm clock
Your radio has two separate alarms which can be set to wake you to either
the radio or a buzzer alarm. In the event of a power interruption your radio
has built in memory that will retain your alarm settings.
Ensure that the time is set correctly before setting the alarms. Alarms
cannot be used when the radio is running on batteries as the clock does
not run in stand-by mode when only powered from batteries.
1. If your radio is in stand-by mode, press and hold the Alarm button
(preset 1) to display the Alarms menu. Go to step 3.
If your radio is switched on, press the Menu button to access the
menu for the current mode. Rotate the Tuning/Select control until
'Main menu' is highlighted on the display. Press the control to enter
the main menu.
2. Rotate the Tuning/Select control until 'Alarms' is selected on the
display. Press the control to see the current alarm settings. If no change
is required, press the Menu or Back buttons to exit.
3. Rotate the Tuning/Select control until the desired alarm (1 or 2) is
highlighted on the display. Press the control to enter alarm setup.
4. Rotate the Tuning/Select control until 'Time' is highlighted on the
display. Press the control to adjust the alarm time.
5. Rotate the Tuning/Select control to choose the alarm hour. Press the
control to conrm the setting.
6. Rotate the Tuning/Select control to choose the alarm minute. Press
the control to conrm the setting. The display will then return to the
alarm setting menu.
If the radio has been set to use a 12 hour clock format, there will also
be an option here for setting AM or PM for the alarm time.
1
1-6
1