Filter
Top Products
15
use MONO to improve the sound. ST/
MONO is also available on the faceplate.
C. WOOFER
In any mode choose WOOFER on the EX-
PERT menu, the rotate the Volume knob to
turn the Subwoofer line out ON or OFF. You
T\Z[OH]LHUHTWSPÄLYPUZ[HSSLK[VKYP]LH
subwoofer.
D. BEEP
In any mode choose BEEP on the EXPERT
menu, then rotate the Volume knob to turn
the Beep sound ON or Off.
E.LOUD
In any mode choose LOUD on the EXPERT
menu, then rotate the Volume knob to turn
the loudness function ON or OFF.
Radio Operations
1. Radio Mode
Press the Mode button to select Radio
mode. The radio frequency appears in the
display.
2. Radio Bands
This unit comes with four bands - three FM
(FM1, FM2, and FM3) and one AM Band.
Each of the four bands can store up to six
preset stations, for a total of 24 (18-FM,6-
AM) pre-set memory stations. Each time
the button is pressed, the radio reception
band changes in the following order:
3. Tuning
There are 3 types of Tuning modes;
Pre-set, Scan, and Manual.
a) Pre-set Tuning
;V\ZL7YLZL[[\UPUN`V\T\Z[ÄYZ[ZH]L
the radio stations to memory;
Press the BND button to select the desired
band, FM1, FM2, FM3, or AM, then press
and hold the AMS button for 2 seconds.
Up to 6 stations will automatically be tuned to.
If 6 receivable stations cannot be received,
the previously stored station will remain in
that memory position.
Press the SET button to recall the stored
pre-set stations.
Each press of the SET button will advance
to the next pre-set frequency.
b) Seek Tuning
Press the button once to seek a lower
frequency or the button to seek a high-
er frequency. When using Seek tuning the
radio will seek for the next strongest radio
signal to tune to.
c) Manual Tuning
Press and hold the
or button until
the word manual appears on the LCD. Then
press to tune to a lower frequency or
the button to tune to a higher frequen-
cy. Leave the unit idle for a few seconds
and it will return to scan tuning.
4. Stereo/Mono
On the faceplate press the ST button,
MONO will be shown on the LCD and the
radio will play in mono. Press the ST button
again, to listen to the radio in stereo.
the default is stereo. When the sound qual-
ity is poor because the signal strength is
weak, use MONO to improve the sound.
5. Local/Distant
Press the LOC button on the faceplate to
switch between local and distant modes.
FM1------FM2------FM3------AM
PRE-SET 2
PRE-SET 3
PRE-SET 4
PRE-SET 1
Basic Operations