Filter
Top Products
Setup and Connections
4
Step 1: Unpack the Digital Receiver
Make sure to locate the remote control.
Step 2: Place Batteries in the
Remote Control
Follow these steps whenever you need to install or change the batteries
in your digital receiver remote.
1. Remove the cover from the battery compartment.
2. Insert batteries in the battery compartment, matching the +
and – end of each battery.
3. Replace the cover.
Step 3: Connecting Your Receiver to
Your TV and VCR
The following sections provide cable and connection information to help
you decide what connection is best for you. Depending on what
components you have, another connection may provide better picture
and audio quality.
Things to Know Before Connecting
Components
Protect Your Components from Power Surges
• Connect all components before plugging any power cords into the
wall outlet.
• Always turn off the digital receiver, TV and other components
before you connect or disconnect any cables.
Position Cables Correctly to Avoid Audio Hum or
Interference
• Insert all cable plugs firmly into their jacks.
• Place the audio/video cables to the sides of the TV’s back panel
instead of straight down the middle after you connect your
components.
• Try not to coil any twin-lead cables and keep them away from the
audio/video cables as much as possible.
• Make sure all antennas and cables are properly grounded. Refer to
the Safety Tips sheet packed with your unit.
To receive signals, your digital receiver
must be connected to a digital antenna.
This antenna must be installed by a
certified, professional installer. Do not
attempt to install the digital antenna
yourself.