Filter
Top Products
6
The PL6.0 II is highly durable and is carefully packaged. We recommend you
inspect the unit carefully after removing it from the packaging, as occasionally
there may be damage due to some unfortunate incident during shipment. Report
any damage to the shipping carrier. We recommend saving the carton and packing
material. It is always a good idea to keep the packaging in case the unit must be
shipped back to your dealer, distributor, or service center. Also note: some freight
companies consider damage claims without the original packing materials invalid.
The QSC shipping box should contain:
1- the PL6.0 II amplifier
2- this Owner’s Manual
3- accessory packet containing:
-rear rack ear mounting kit
-terminal-block connectors for inputs and remote power supply control
-four adhesive feet
Unpacking and Inspection
UNPACKING
Supporting the Front of the Amplifier
Rack mounting of the amplifier is optional. The PL6.0 II is designed to fit a normal 19-inch width equipment rack.
Secure the front rack ears using four machine screws with washers, as shown below. Verify operating voltage
printed on the serial number plate; it is located on the side panel by the AC cord entry. Once the amplifier is
mounted, it may be difficult to read this information (see p.9).
CAUTION!
To minimize the
risk of injury, we
recommend an
assistant help
support the
amplifier during
rack installation.
SETUP- Rack Mounting
When installing
equipment into a
rack, distribute
the units evenly.
Otherwise, haz-
ardous conditions
may be created by
an uneven weight
distribution.