Filter
Top Products
11
Parallel Mode
Bridge Mode
In Parallel Mode, the channel 1 and
channel 2 input connectors are
connected in parallel. Applying an
input signal to either input will drive
both channels. Make sure only one
input signal is applied to the ampli-
fier when operating in Parallel mode.
Each channel still has independent
gain control, clip limiting, and output
connection, just like Stereo Mode.
To operate in Parallel Mode, set the
Mode Switch to PARALLEL. Connect
the single input signal and the two
speaker channels.
In Bridge Mode, both output chan-
nels are combined into one higher
power channel. The result is one
output with about 4 times the peak
power and about 3 times the sus-
tained power of a single channel.
Use only CH1’s input. Output connec-
tions for Bridge Mode are the two
red binding posts. Connection
polarity is clearly marked (CH1 red
binding post= positive, CH2 red
binding post= negative).
To operate in Bridge Mode, set the
Mode Switch to the BRIDGE position.
Connect the single input and the
single speaker channel.
SETUP- Operating Mode Selection
Speakon connectors are not recommended for
Bridge mode use! Use binding post outputs.
Speakons are not wired for Bridge mode output!