Filter
Top Products
Listening to your system
06
54
En
Setting the Up Mix function
In a 7.1-channel surround system with surround
speakers placed directly at the sides of the listening
position, the surround sound of 5.1-channel sources is
heard from the side. The Up Mix function mixes the
sound of the surround speakers with the surround back
speakers so that the surround sound is heard from
diagonally to the rear as it should be.
1
•Using the Up Mix function is effective when the
speakers in the 7.1-channel surround system are set
up as recommended in the example on page 17.
•Depending on the positions of the speakers and the
sound source, in some cases it may not be possible
to achieve good results. In this case, set the setting to
OFF.
1 Switch the receiver into standby.
2 While holding down
ENTER
on the front panel,
press
STANDBY/ON
.
The display shows RESET NO .
Use TUNE +/– (or / on the remote control) to select
UP MIX ON , and then use PRESET +/– (or / on
the remote control) to select ON or OFF.
3 Press
ENTER
to confirm.
• When set to ON, the UP MIX indicator on the front
panel lights.
Selecting MCACC presets
• Default setting: MEMORY 1
If you have calibrated your system for different listening
positions
2
, you can switch between settings to suit the
kind of source you’re listening to and where you’re sitting
(for example, watching movies from a sofa, or playing a
video game close to the TV).
• While listening to a source, press , then
press
MCACC
.
Press repeatedly to select one of the six MCACC presets
3
.
See Data Management on page 82 to check and manage
your current settings.
Note
1 • Set to ON regardless of this setting when playing DTS-HD signals.
• May automatically be set to OFF even when set to ON, depending on the input signal and listening mode.
?
C
SW
L R
SL SR
SBL SBR SBL SBR
C
SW
L R
SL SR
Up Mix OFF Up Mix ON
INPUT
SELECTOR
STANDBY/ON
PHONES
BAND
TUNE
TUNE
PHASE
CONTROL
AUTO SURR
/ALC/
STREAM DIRECT
STEREO
ADVANC
MCACC
MCACC SETUP MIC
SPEAKERS
USB
CONTROL
MULTI-ZONE
ON
/
OFF
HDMIPQLS
PRESET
PRESET
TUNER EDIT
ENTER
iPod
iPhone
VIDEO
CAMERA
HDMI 4
2 Different presets might also have separate calibration settings for the same listening position, depending on how you’re using your system.
These presets can be set in Automatically setting up for surround sound (Auto MCACC) on page 39 or Automatic MCACC (Expert) on page 72,
either of which you should have already completed.
3 • These settings have no effect when headphones are connected.
• You can also press / to select the MCACC preset.
123
SLEEP
HDMI OUT
MCACCSIGNAL SEL
456
DIMMERA.ATTSBch
789
CLASS
MASTER
CH LEVELD.ACCESS
0
ENTER
PHASE CTRLTHX STATUS
REMOTE
SETUP
TV/DTV
AUDIO
INFO
DISP
MPX PQLS
CH
RECEIVER
TV CTRL
RECEIVER
VSX-LX52_SVYXJ.book 54 ページ ２００９年２月２６日 木曜日 午後４時３１分