Filter
Top Products
Using other functions
11
61
En
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the front panel
TONE
button,
press and hold
STANDBY/ON for about three
seconds.
The display shows RESET?.
3 Press the front panel
ENTER
button.
The display shows RESET OK?.
4Press
SYSTEM SETUP
to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Default system settings
Setting Default
HDMI Audio Amp
Digital Video Conversion On
Speakers A
Surround Back System Normal (SBch)
Speaker System Front SMALL
Center SMALL
Surr. SMALL
SB SMALLx2
SW YES
Crossover 80 Hz
X-Curve OFF
THX Audio Setting 0.0–0.3m
Inputs
See Input function default and possible settings on page 56.
SR+
SR+ Control On/Off OFF
SR+ Volume Control On/Off OFF
Monitor Out OFF
DSP
MCACC Position Memory M1: MEMORY 1
Surround back channel
Processing
ON
Phase Control On
Sound Retriever Off
Sound Delay 0 frame
Dual Mono CH1
DRC OFF
SACD Gain 0 dB
LFE Attenuate 0 dB
I/P Convert Auto
Auto delay OFF
Digital Safety OFF
Effect Level Extended Stereo 90
Other modes 50
2 PL II Music Options Center Width 3
Dimension 0
Panorama OFF
Neo:6 Options Center Image 3
All Inputs Listening Mode (2 ch) AUTO SURROUND
Listening Mode (x ch) AUTO SURROUND
Listening Mode (HP) STEREO
See also Setting the AV options on page 58 for other default DSP
settings.
MCACC
Channel level (M1–M6) 0 dB
Speaker Distance (M1–M6) 3.0 m
Standing Wave
(M1–M6)
Standing Wave On/
Off
ON
ATT 0 dB
SWch Wide Trim 0.0
EQ Data (M1–M6) All channels/bands 0 dB
EQ Wide Trim (M1–M6) 0.0 dB
Setting Default
VSX-LX50_HY.book Page 61 Thursday, March 8, 2007 1:18 PM