Filter
Top Products
14
En
Easy Setup Guide Part2
8
Select AUTO SETTING with the 5∞
buttons and press ENTER.
9
Some auto setup instructions will be
listed, make sure to follow them.
Make sure you have: hooked up the microphone and moved
obstacles to the speakers out of the way. If you have a
subwoofer make sure it is turned on and has the volume
turned up.
WARNING: The test tones are very loud!! Make sure there
are no infants or small children in the room and that no one
who will be scared, upset or injured by loud noise is present.
You yourself may want to wear earplugs. It is possible to
lower the volume of test tones, but this could result in
incorrect speaker settings.
10
If you have followed all setup instructions
and warnings above make sure that the
arrow is pointed to START and press
ENTER. Be prepared for loud test tones.
Try to be as quiet as possible after hitting ENTER. The test
tones may take up to 30 seconds.
The volume automatically increases to 0 dB, then the system
will output some test tones and establish ambient noise
levels, the microphone status, and what speakers you hooked
up.
11
Check the speaker settings on the OSD
If they match your speaker configuration make sure OK is
selected and press ENTER. The test tones will be output
loudly again. The test tones may take up to 5 minutes this
time.
After it has finished, you see the SPEAKER SYSTEMS CHECK
screen. If you want to view the settings select NEXT and
press ENTER repeatedly. If not, simply go to step 13.
If they do not match the speaker configuration you hooked up
and you want to try again select RETRY with 5∞ buttons and
press ENTER. Follow the instructions above from step 10.
If you get an error message instructing you to do something,
follow the instructions and RETRY with 5∞ buttons and
press ENTER.
If the speaker settings do not match the speaker configura-
tion you connected and you want to input the settings
manually select ERR=FIX SP with the 5∞ buttons, press
ENTER. Go to step 12.
If you see an ERR message in the right side column, there
may be a problem with the speaker connection. If selecting
RETRY doesn't fix the problem, turn off the power and check
the speaker connections.
10
Auto Surround Setup
Please Wait
Caution!!
Test tone is
output loudly.
[Cancel]
Auto Surround Setup
Set microphone
Turn on subwoofer
[ Start ]
[ Cancel ]
Auto Surround Setup
Now Analyzing
•••
Environment Check
Ambient Noise [OK]
Microphone [OK]
Speaker YES/NO [OK]
[Cancel]
Check!!
Front [ YES ]
Center [ YES ]
Surround [ YES ]
SurrBack [ YES
2 ]
Subwoofer [ YES ]
[OK]
[Retry]
[ERR Fix SP.]
[Return to Menu]
11
\
\
Auto Surround Setup
Now Analyzing
•••
Surround Analysis
Speaker Systems [OK]
Channel Delay [OK]
Channel Level [OK]
Acoustic Cal EQ [OK]
[Cancel]
Speaker Systems Check
Front [SMALL]
Center [SMALL]
Surround [SMALL]
SurrBack [SMALL
X
2]
Subwoofer [ YES ]
[Next ]
[Exit ]
\
8
1.Surround Setup
[ SurrBack System
[ Auto Setting
[ Quick
[ Normal
[ Expert
[ Exit
]
]
]
]
]
]