Filter
Top Products
Using other functions
10
70
En
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the front panel
AV
PARAMETER
button, press and hold
STANDBY/ON
for about three seconds.
The display shows
RESET?
.
3 Press the front panel
ENTER
button.
The display shows
RESET OK?
.
4 Press
SETUP
to confirm.
OK
appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Default system settings
Setting
Default
HDMI Audio Amp
Digital Video Conversion On
Speakers A
Surround Back System Normal (SBch)
Speaker System Front SMALL
Center SMALL
Surr. SMALL
SB SMALLx2
SW YES
Crossover 80 Hz
Bass Peak Level OFF
X-Curve OFF
THX Audio Setting 0.0–0.3 m
Inputs
See
Input function default and possible settings
on page 64.
Multi Room
Room 2 Volume Type Variable
Room 2 Volume -60
SR+
SR+ Control On/Off OFF
SR+ Volume Control On/Off OFF
Monitor Out OFF
DSP
MCACC Position Memory M1: MEMORY 1
Surround back channel
Processing
ON
Phase Control On
Sound Delay 0 frame
Sound Retriever Off
Dual Mono CH1
DRC OFF
SACD Gain 0 dB
Digital Safety OFF
Effect Level 7 ch Stereo 90
Other modes 50
2
PL II Music Options Center Width 3
Dimension 0
Panorama OFF
Neo:6 Options Center Image 3
All Inputs Listening Mode (2 ch) AUTO SURROUND
Listening Mode (x ch) AUTO SURROUND
Listening Mode (HP) STEREO
See also
Setting the AV options
on page 66 for other default DSP
settings.
MCACC
Channel level (M1–M6) 0 dB
Speaker Distance (M1–M6) 3.0 m
Standing Wave
(M1–M6)
Standing Wave On/
Off
ON
ATT 0 dB
SWch Wide Trim 0.0
EQ Data (M1–M6) All channels/bands 0 dB
EQ Wide Trim (M1–M6) 0.0 dB
Setting
Default
VSX_AX4ASi.book.fm 70 ページ ２００６年６月８日 木曜日 午後１２時２３分