Filter
Top Products
Using other functions
10
69
En
Using the sleep timer
The sleep timer switches the receiver into standby after a
specified amount of time so you can fall asleep without
worrying about the receiver being left on all night. Use
the remote control to set the sleep timer.
• Press
SLEEP
repeatedly to set the sleep time.
• You can check the remaining sleep time at any time
by pressing
SLEEP
once. Pressing repeatedly will
cycle through the sleep options again.
1
Dimming the display
You can choose between four brightness levels for the
front panel display. Note that when selecting sources,
the display automatically brightens for a few seconds.
• Press DIMMER repeatedly to change the brightness
of the front panel display.
Switching the speaker impedance
We recommend using speakers of 8
Ω
with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6
Ω
impedance rating. Use
the front panel controls to do this.
• With the receiver in standby, press
STANDBY/
ON
while holding down the
SPEAKERS
button.
Each time you do this, you switch between the
impedance settings:
•
SP 6 OHM
– Use this setting if your speakers are
rated at 6
Ω
.
•
SP 8 OHM
– Use this setting if your speakers are
rated at 8
Ω
or more.
Checking your system settings
Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
1 Press
STATUS
to check the system settings.
These appear on both the OSD and the front panel
display.
2
The front panel display shows each of the following
settings for two seconds each:
2 When you’re finished, press
STATUS
again to
switch off the display.
Note
1 You can also switch off the sleep timer simply by switching off the receiver.
SLEEP
+
10
SR
+
ANALOG
ATT
DISC
VIDEO
SEL
DIMMER
S.RETRIEVER
CLASS
D.ACCESS
ENTER
AVPARAMETER CHLEVEL
Off
30 min 60 min
90 min
SLEEP
+
10
SR
+
ANALOG
ATT
DISC
VIDEO
SEL
DIMMER
S.RETRIEVER
CLASS
D.ACCESS
ENTER
AVPARAMETER CHLEVEL
2 If the Pure Direct mode is switched on, some settings above will show
OFF
, even though they are on.
Input source Listening mode
Signal Select Surround Back Processing
Sound Retriever Video Select
MCACC Position Room2 / REC SEL
Room3
SHIFT
STATUS
MCACC S.DIRECT
MULTI OPE
SIGNAL SEL
PHOTO
SBch
STEREO
AUDIO SUBTITLE
ADV. SURR
STANDARD
PHASE
THX
HDD
CH
CH
DVD
DISP
STATUS
96kHz STEREO
Signal Select : AUTO
SBch Processin : OFF
Retriever : ON
Video Select : OFF
MCACC Position : M1
Room2/REC SEL : SOURCE
Room3 : SOURCE
VSX_AX4ASi.book.fm 69 ページ ２００６年６月８日 木曜日 午後１２時２３分