Filter
Top Products
Additional information
13
69
En
English
Français
Deutsch
Nederlands
Italiano
Español
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the TONE button,
press and hold the
STANDBY/ON button for
about three seconds.
3 When you see RESET? appear in the
display, press
ENTER
.
OK?
shows in the display.
4 Press
SETUP
to confirm.
OK
appears in the display to indicate that the
receiver has been reset to the factory settings.
Switching the speaker
impedance
We recommend using speakers of 8
Ω
with
this system, but it is possible to switch the
impedance setting if you plan to use speakers
with a 6
Ω
impedance rating.
• With the receiver in standby, press
STANDBY/ON
while holding down the
SPEAKERS
button.
Each time you do this, you switch between the
impedance settings:
•
SP 6 OHM
– Use this setting if your
speakers are rated at 6
Ω
.
•
SP 8 OHM
– Use this setting if your
speakers are rated at 8
Ω
or more.
Changing the TV format setting
If the System Setup menu is not displayed
correctly, it may be that the TV system is set
incorrectly for your country or region.
• With the receiver in standby, press
STANDBY/ON while holding down the
SIGNAL SELECT button.
The display shows the new setting (
PAL
or
NTSC
).
VSX-917V.book.fm 69 ページ ２００７年２月２２日 木曜日 午後８時２０分