Filter
Top Products
Additional information13
66
En
Chapter 13:
Additional information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Take a look at the other
components and electrical appliances being used, because sometimes the problem may lie there.
If the trouble isn’t sorted out even after going through the checks below, ask your nearest Pioneer
authorized independent service company to carry out repair work.
•
If the unit does not operate normally due to external effects such as static electricity disconnect
the power plug from the outlet and insert again to return to normal operating conditions.
Problem
Remedy
The power does not turn on. • Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear panel. This
could cause the receiver to shut off automatically.
• The unit may have been switched on using the wrong voltage setting. Make sure
you switch the
VOLTAGE SELECTOR
on the rear panel to the right voltage for your
country or region, then reset the unit (page 69) before switching on again.
The receiver suddenly switches
off and the power indicator
blinks.
• After about a minute (you won’t be able to switch the unit on during this time),
switch the receiver back on. If the message persists, call a Pioneer authorized
independent service company.
No sound is output when a
function is selected.
• Make sure the component is connected correctly (refer to
Connecting up
on
page 12).
• Press
MUTE
on the remote control to turn muting off.
• Press
SPEAKERS
to select the proper speaker set (see
Switching the speaker
system
on page 58).
• Press
SIGNAL SELECT
to select the proper input signal (see
Choosing the input
signal
on page 34).
No image is output when a
function is selected.
• Make sure the component is connected correctly (refer to
Connecting up
on
page 12).
• Select the correct component (use the input select buttons).
• Check
Assigning the component video inputs
on page 62 to make sure you’re
assigned the correct input.
• The video input selected on the TV monitor is incorrect. Refer to the instruction
manual supplied with the TV.
No sound from subwoofer. • Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• The Dolby Digital or DTS source you are listening to may not have an LFE channel.
• Switch the subwoofer setting in
Speaker Setting
on page 44 to
YES
or
PLUS
.
• Switch the
LFE Attenuator Setup
on page 64 to
LFEATT 0
or
LFEATT 10
.
No sound from surround or
center speakers.
• Connect the speakers properly (refer to page 20).
• Refer to
Speaker Setting
on page 44 to check the speaker settings.
• Refer to
Channel Level
on page 45 to check the speaker levels.
VSX-917V.book.fm 66 ページ ２００７年２月２２日 木曜日 午後８時２０分