Filter
Top Products
Additional information13
68
En
HDMI
Can’t operate the remote
control.
• Replace the batteries (refer to page 6).
• Operate within 7 m, 30° of the remote sensor (refer to page 28).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Unplug anything connected to the
CONTROL IN
jack and use remote normally
(see
Operating other Pioneer components
on page 50).
The SR cable is connected, but
the connected components
can’t be operated with the
remote.
• Reinsert the SR cable, making sure it’s connected to the right jack (see
Using this
receiver with a Pioneer plasma display
on page 60).
• Make sure an analog connection has been made between the units.
• This feature only works with Pioneer products.
The display is dark or off. • Press
DIMMER
on the control repeatedly to return to the default.
USB mass storage device is
not recognized by the receiver.
• Try switching the receiver off, then on again.
• Make sure you have completely inserted the USB connector to this receiver.
• Check that the memory format is FAT16 or FAT32 (FAT12, NTFS and HFS are not
supported).
• USB devices with an internal USB hub are not supported.
USB ERR3
shows in the display
when connecting a USB
device.
• If this message continues to appear after going through all the checks in
Important
on page 36 of
USB playback
, take the unit to your nearest Pioneer
authorized service center or your dealer for servicing.
Can’t play audio files. • The WMA or MPEG-4 AAC files were recorded using DRM (digital rights
management), or the bit rate/sampling rate is not compatible (see
Compressed
audio compatibility
on page 37). This is not a malfunction.
Problem
Remedy
Symptom Remedy
No picture or sound.
• If the problem still persists when connecting your HDMI component directly to
your monitor, please consult the component or monitor manual or contact the
manufacturer for support.
No picture.
• Depending in the output settings of the source component, it may be outputting a
video format that can’t be displayed. Change the output settings of the source, or
connect using the component, S-video or composite jacks.
OSD does not appear.
• The OSD will not appear if you have connected using the HDMI output to your TV.
Use component, S-video, or composite connections when setting up the system.
No sound, or sound suddenly
ceases.
• Since the HDMI audio signal is sent through this receiver to your TV, you need to
make separate connections for audio if you want to hear your HDMI component
through this system. See
Connecting using HDMI
on page 57 for more on this.
• If you’ve made separate connections for audio, make sure you have assigned the
analog/digital jack(s) to the corresponding HDMI input for the component. See
Assigning the HDMI inputs
on page 63 to do this.
• Check the audio output settings of the source component.
VSX-917V.book.fm 68 ページ ２００７年２月２２日 木曜日 午後８時２０分