Filter
Top Products
Listening to your system05
34
En
Enhancing dialog
• Default setting:
OFF
The Dialog Enhancement feature localizes
dialog in the center channel to make it stand
out from other background sounds in a TV or
movie soundtrack.
• Press DIALOG (DIALOGUE
ENHANCEMENT) to switch dialog
enhancement on or off.
Using the tone controls
Depending on what you are listening to, you
may want to adjust the bass or treble using the
front panel tone control.
1
1 Press TONE to select the frequency you
want to adjust.
Press to switch between
BASS
and
TREBLE
.
2 Use the
MULTI JOG
dial to change the
amount of bass or treble as necessary.
Wait about five seconds for your changes to be
input automatically.
Playing other sources
1 Turn on the power of the playback
component.
2 Turn on the power of the receiver.
3 Select the source you want to playback.
Use the input select buttons.
2
4 Start playback of the component you
selected in step 1.
Choosing the input signal
• Default setting:
AUTO
You need to hook up a component to both
analog and digital inputs on the rear of the
receiver to select between input signals.
3
• Press
SIGNAL SEL (SIGNAL SELECT
) to
select the input signal corresponding to the
source component.
Each press cycles through the options as
follows:
•
AUTO
– This is the default setting. The
receiver selects the first available signal in
the following order:
DIGITAL
;
ANALOG
.
•
ANALOG
– Selects an analog signal.
•
DIGITAL
– Selects an optical or coaxial
digital signal.
When set to
DIGITAL
or
AUTO
,
2
DIGITAL
lights when a Dolby Digital signal is input, and
DTS
lights when a DTS signal is input.
Selecting the multichannel
analog inputs
If you have connected a decoder or a DVD
player with multichannel analog outputs to this
receiver (page 15), you must select the analog
multichannel inputs for surround sound.
4
Note
1 The tone controls are only available when Stereo or Front Stage Surround Advance mode are selected (except when
STEREO
is selected using
AUTO
SURROUND
).
2 If your source is the TV’s built-in tuner, switch to the channel you want to watch, otherwise make sure that the TV’s video input
is set to this receiver (For example, if you connected this receiver to the
VIDEO
jacks on your TV, make sure that the
VIDEO
input
is selected). Turn down the volume of your TV so that all the sound is coming from the speakers connected to this receiver.
3• This receiver can only play back Dolby Digital, PCM (32 kHz to 96 kHz), DTS and WMA9 Pro digital signal formats. With other
digital signal formats, set to
ANALOG
.
• You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make
the proper digital connections (
Connecting other audio components
on page 16) and set the signal input to
DIGITAL
.
• Some DVD players don’t output DTS signals. For more details, refer to the instruction manual supplied with your DVD player.
4• During playback from the multichannel inputs, you can’t use any of the sound features/modes and only the volume and
channel levels can be set.
• You can’t listen to your speaker B (Second Zone) system during playback from the multichannel inputs.
VSX-917V.book.fm 34 ページ ２００７年２月２２日 木曜日 午後８時２０分