Filter
Top Products
99
Techno Tidbits & Problem-solving
EXPERT
During playback of a DVD
audio source, the player
shows a transfer rate of
96kHz, but the receiver does
not.
During playback of a 96kHz
source, the display doesn't
show 96kHz
Remote control
Cannot be remote
controlled.
Other components can't be
operated with the system
remote.
The SR cable is connected,
but the connected
components can't be
operated with the remote.
• The multichannel connections are analog,
so there is no digital transfer.
• The receiver may be on a different mode
than STEREO.
• One of the DIGITAL NR, MIDNIGHT,
LOUDNESS, or TONE features is switched
on.
• The remote control batteries have worn
out.
• Too far away or improper angle of
operation.
• There is an obstacle between the
receiver and the remote control.
• Strong light such as fluorescent light is
shining onto the unit's remote control signal
light-receiving window.
• A cord is connected to the CONTROL IN
terminal on this unit.
• The IR Receiver type is mismatched with
the setting.
• The preset code settings are wrong.
• The batteries wore out and the system
settings were cleared.
• The SR cable hasn't been connected
properly.
• The rest of the component connection
have not been made.
• The component you have hooked up is
not SR compatible.
• This is not a malfunction. See the
player's manual for more details.
• Switch to STEREO mode (see page 43).
• Turn it/them off (see page 47–49).
• Replace the batteries (see page 7).
• Operate within 25 feet and a 30° angle of
the remote sensor on the front panel (see
page 8).
• Remove the obstacle or operate from
another position (see page 8).
• Avoid exposing the remote sensor on the
front panel to direct light.
• Connect cord to the correct jack.
• Disconnect the IR Receiver from the rear
panel, and set to the other IR Receiver type
using the remote control.
• Input the correct preset code.
• Reset the proper system settings.
• Reinsert the SR cable, making sure it is
the right jack (see page 71).
• Make sure an analog connection has
been made between the units.
• This is not a malfunction.
Symptom Cause Remedy
If the unit does not operate normally due to external effects such as static electricity
Disconnect the power plug from the outlet and insert again to return to normal operating conditions.