Filter
Top Products
59
BASIC
Remote Control of Other Components
1
While holding down the REMOTE
SETUP button press to select the
preset recall setup mode.
The LED begins to blink.
To cancel the preset recall setup mode press REMOTE
SETUP.
2
Press the MULTI CONTROL button
for the component you want to
control.
The LED lights continously.
3
Point the remote toward the
component to be controlled, enter
the 4 digit setup code (see pages 93-
94 for codes).
The LED blinks.
After a code has been input the power of the compo-
nent being input will turn on or off.
The remote will return to the previous mode after
thirty seconds of inactivity.
The power of the component being input will only turn
on or off if that component is able to be turned on
directly by remote control.
Repeat steps 2 through 3 to assign preset codes
for as many components as necessary.
If you can't get your component to respond to
any of the codes you can still program the
component into the remote control using the
procedure in the next section.
4
Press the REMOTE SETUP button to
exit the preset recall setup mode.
The remote control and receiver return to their
previous operation modes.
Setting Up the Remote Control to Control Other
Components
In addition to controlling the receiver, the supplied remote control can operate your other components (VCR, TV,
DVD, CD, etc.) after you program it to do so. In this way, instead of fumbling with many different controls and
buttons, you only need to use one remote control. If your component(s) are listed in the remote control's
memory, simply follow the steps below. If your component(s) are not listed, or if you want the remote to learn
additional operations, you can use the learning mode to input the information from the remote controls supplied
with your other components.
Recalling Settings Stored in the Remote Control
The following steps show you how to recall the setting stored in the remote control. Once a setting is recalled
and the component assigned, you can use this remote to easily operate the component.
• To exit from the remote control setup mode at any time, press REMOTE SETUP.
• See "Using Remote Control with Other Components" on pages 61–62 to operate your other
components.
• The TUNER button cannot be assigned.
memo
SOURCE
MULTI CONTROL
RECEIVER
MOVIE MUSIC
ENTER
MULTI
OPERATION
SURROUND
MODE
STEREO/
DIRECT
SYSTEM
OFF
ACOUSTIC
EQ
SB CH
MODE
INPUT
MIDNIGHT
CHANNEL
−
+
−
CHANNEL
+
DTV ON/OFF BAND
DIMMER TONE
LOUDNESS EFFECT/CH SEL
SIGNAL SEL
BASS/TREBLE DISC
DNR
VIDEO SEL
SUB TITLE
REMOTE
SETUP
HI-BIT
D.ACCESS
MPX
TV CONTROL
CLASS
MUTE
MENU TOP MENU
TUNER EDIT
GUIDE
SYSTEM
SETUP
AUDIO
RETURN
CHANNEL VOLUME
INPUT
S
ELE
C
T
+
10
MULTI CH
INPUT
RECEIVER
ST
TUNE
MASTER
VOLUME
ST
TUNE
DVD/LD
ENTER
ENTER
VCR 2
TV/SAT
CD
VCR/DVR TV CONT
TUNER
RECEIVER
1
1
LED
3
2