Filter
Top Products
60
Remote Control of Other Components
Programming Signals from Other Remote Controls (LEARNING Mode)
If preset codes are not available for your component(s), or the available preset codes do not operate correctly,
you can use this procedure to program in signals from the remote control(s) of your other component(s). These
steps can also be used to add further operations to the remote control that were successfully set with the
stored settings (see page 59).
1
While holding down the REMOTE
SETUP button press to select the
learning setup mode.
The LED begins to blink.
To cancel the learning setup mode press REMOTE SET
UP.
2
Press the MULTI CONTROL button
for the component you want to
control.
The LED lights continously.
3
Press the button to be programmed.
For example DVD/LD
The LED blinks rapidly.
• The TV , TV INPUT SELECT, TV CHANNEL +/–
and TV VOLUME +/– buttons are only available for
learning when programming TV CONTROL
operations.
4
Point the remote controls at each
other and press the button on the
other remote control for the
operation you wish to program .
1 Point the remote controls toward each other.
2 Press the button on the other remote control
corresponding to the operation you wish to
program.
The LED will turn off and then light again.
To program additional operations for the current
component, repeat steps 3 and 4.
To program operations for another component,
repeat steps 2 through 4.
5
Press the REMOTE SETUP button to
exit the learning setup mode.
The remote control and receiver return to their
previous operation modes.
memo
• To exit from the remote control setup mode at any time, press REMOTE SETUP.
• You can also program the 5˜∞˜2˜3 and ENTER buttons with the LEARNING mode.
• The TUNER button cannot be assigned.
• Some commands cannot be learned.
SOURCE
MULTI CONTROL
RECEIVER
MOVIE MUSIC
ENTER
MULTI
OPERATION
SURROUND
MODE
STEREO/
DIRECT
SYSTEM
OFF
ACOUSTIC
EQ
SB CH
MODE
INPUT
MIDNIGHT
CHANNEL
−
+
−
CHANNEL
+
DTV ON/OFF BAND
DIMMER TONE
LOUDNESS EFFECT/CH SEL
SIGNAL SEL
BASS/TREBLE DISC
DNR
VIDEO SEL
SUB TITLE
REMOTE
SETUP
HI-BIT
D.ACCESS
MPX
TV CONTROL
CLASS
MUTE
MENU TOP MENU
TUNER EDIT
GUIDE
SYSTEM
SETUP
AUDIO
RETURN
CHANNEL VOLUME
INPUT
S
ELE
C
T
+
10
MULTI CH
INPUT
RECEIVER
ST
TUNE
MASTER
VOLUME
ST
TUNE
DVD/LD
ENTER
ENTER
VCR 2
TV/SAT
CD
VCR/DVR TV CONT
TUNER
RECEIVER
1
1
3
2
LED
2-8 inches
SOURCE
MULTI CONTROL
RECEIVER
MOVIEMUSIC
ENTER
MULTI
OPERATION
SURROUND
MODE
STEREO/
DIRECT
SYSTEM
OFF
ACOUSTIC
CAL
SB CH
MODE
INPUT
MIDNIGHT
CHANNEL
−
+
−
CHANNEL
+
DTV ON/OFF BAND
RF ATT
DIMMER TONE
LOUDNESS EFFECT/CH SEL
SIGNAL SEL
BASS/TREBLE DISC
DNR
VIDEO SEL
SUB TITLE
REMOTE
SETUP
HI-BIT
D.ACCESS
MPX
TV CONTROL
CLASS
MUTE
MENU TOP MENU
TUNER EDIT
GUIDE
SYSTEM
SETUP
AUDIO
RETURN
CHANNELVOLUME
I
N
PUT
S
E
LE
C
T
+
10
MULTI CH
INPUT
RECEIVER
ST
TUNE
MASTER
VOLUME
ST
TUNE
DVD/LD
ENTER
ENTER
VCR 2
TV/SAT
CD
VCR/DVR TV CONT
TUNER
RECEIVER
Buttons
that are
able to
learn new
commands