Filter
Top Products
Speaker Setup Guide
01
6
En
Standard surround setup
This is a standard multichannel surround sound speaker
setup for optimal 5.1 channel home theater sound.
The center speakers can be installed independently in
the center if desired.
1 Attach the smaller non-skid pads to the base of
each of the front, center and surround speakers. The
four large non-skid pads are for the receiver
subwoofer (as shown).
Use the adhesive side of the pads to attach them to the
base (flat surface) of each speaker.
2 (When mounting center speakers to right and
left) Stack the speakers and fix with the bracket.
Each speaker is provided with a color-coded indicator on
the model label on the rear side to assist identification.
Refer to the color indicators and install the speakers
correctly.
As shown in the illustration, stack the speakers with the
front speaker on the bottom and center speaker on top,
then align the 1st and 3rd screw holes from the top of the
bracket with the upper screw holes on the back of the
speakers, and fasten the two securely.
Caution
• Do not attempt to carry the speakers when they are
connected with the bracket. Doing so may cause
damage to the bracket or worsen damage to the
bracket and speakers in the event they are dropped.
3 Connect the speaker system.
Refer to
Connecting up
to connect the speakers properly.
After connecting everything, place the speakers as
shown in the diagram above for optimal surround sound.
After placing the speakers, run the Auto MCACC setup
(page 15) to complete your surround sound setup.
Surround left
*When center speakers are placed in the center.
Surround right
CenterCenter
Front
left
Listening position
Listening position
Front
right
Receiver
subwoofer
Center
Front
left
Front
right
Front, Center and Surround speakers
Non-skid pads
(small) x 24
Receiver subwoofer
Non-skid pads
(large) x 4
Front speaker
Center speaker
Left
Green
White
Green
Red
Right
Color indicator
Model label
Bracket
Screw
Center speaker
Front speaker
HTP-330.book 6ページ ２００７年３月２７日 火曜日 午後６時８分