Filter
Top Products
Additional information
09
26
En
Chapter 9
Additional information
Setting the sleep timer
The sleep timer switches off the receiver subwoofer after
a specified time so you can fall asleep without worrying
about it.
1
1 Press the
SLEEP
button to select an option.
Choose between the following options:
•
SLP ON
– Switches off after about an hour
•
SLP OFF
– Cancels the sleep timer
After selecting
SLP ON
, you can press
SLEEP
again to
check how much time is left. Each line indicates
approximately 12 minutes (remaining):
Dimming the display
You can choose to dim the display if you find it too
bright.
2
1 Press
SETUP
.
2 Use the
/
(cursor left/right) buttons to select
DIMMER
then press
ENTER
.
3 Use the
/
(cursor up/down) buttons to select
LIGHT or DARK then press
ENTER
.
DTS CD setting
If you play a DTS-encoded CD, you will need to change
this setting to hear the decoded signal.
1Switch the system into standby.
2 Press
SETUP
.
3 Use the
/
(cursor left/right) buttons to select
CD TYPE from the menu, then press
ENTER
.
4 Use the
/
(cursor up/down) buttons to select a
setting, then press
ENTER
.
Select from:
•
NORMAL
– Use for playback of regular audio CDs.
Some DTS-encoded CDs will output noise when
played.
•
DTS-CD
– Use for playback of DTS-encoded CDs, but
note that the beginning of regular CD tracks may be
skipped.
Resetting the system
Use this procedure to reset all system settings to the
factory default.
1Switch the system on.
2 Press and hold SURROUND then press the
STANDBY/ON button on the display unit.
The next time you switch on, all the system settings
should be reset.
Note
1 The display dims when the sleep timer is set.
2 The display dims when the sleep timer is set, regardless of this setting.
ST
TUNE
ST
ENTER
ENTER
CLEAR
SOUND
SETUP
TEST
TONE
SLEEP
SR
SLEEP
SLP --- --
ST
TUNE
TUNE
ST
ENTER
ENTER
CLEAR
SOUND
SETUP
TEST
TONE
SOUND
RETRIEVER
SLEEP
SR
ST
TUNE
TUNE
ST
ENTER
SETUP
HTP-330.book 26 ページ ２００７年３月２７日 火曜日 午後６時８分