Filter
Top Products
Surround sound settings
07
22
En
3 Use
/
(cursor up/down) to select a setting.
Select one of the following:
•
DRC OFF
(default)
– No dynamic range adjustment
(use when listening at higher volume)
•
DRC MID
– Mid setting
•
DRC HIGH
– Dynamic range is reduced (loud sounds
are reduced in volume while quieter sounds are
increased)
4 Press
ENTER
to exit.
Dual mono setting
Specifies how dual mono encoded Dolby Digital or DTS
soundtracks should be played. You can also use this
setting to switch the audio channel on DVD-RW discs
recorded with bilingual audio.
1 Press
SETUP
.
2 Use the
/
(cursor left/right) buttons to select
DUALMONO, then press
ENTER
.
3 Use
/
(cursor up/down) to select a setting.
Select one of the following:
•
CH1 MONO
(default)
– Only channel 1 is played
•
CH2 MONO
– Only channel 2 is played
•
CH1/CH2
– Both channels are played through the
front speakers
4 Press
ENTER
to exit.
Adjusting the channel levels using the
test tone
If you prefer, you can set the channel levels using a test
tone as a reference, rather than playing a source (see
Channel level setting
on page 21). A test tone is played
through each speaker in turn, allowing you to adjust the
level as it plays.
Note that the channel level settings for stereo sources
are independent of the settings for surround sound
sources.
1 Press
SURROUND
to select the Auto listening
mode.
• If you want to set the channel levels for stereo (two
channel) playback, select the
STEREO
listening
mode.
2 Press
TEST TONE
.
The test tone is output from each speaker in turn.
3While a test tone is playing, use the
/
(cursor
up/down) buttons to adjust that channel level.
The aim is to adjust the levels so that you hear the test
tone at the same volume from each speaker. You can
adjust the level of each channel by ±10 dB.
• You can adjust the overall volume of test tone output
using the
VOLUME
+/–
buttons (this does not affect
the channel level settings).
• If the system is in Stereo or Virtual mode, you will not
be able to adjust the center or surround channels.
• Because of the ultra low frequencies the subwoofer
produces, it may sound quieter than it really is. We
suggest adjusting the subwoofer level while listening
to a source. See the method described in
Channel
level setting
on page 21.
4When you’re done, press
ENTER
to exit test tone
setup.
• If you use the Auto MCACC feature again, it will
overwrite the settings you have made here.
ST
TUNE
TUNE
ST
ENTER
ENTER
CLEAR
SOUND
SETUP
TEST
TONE
CHANNEL
SOUND
RETRIEVER
MCACCADVANCED F.S.SURRSURROUND
SLEEP
VOLUME
SR
ST
TUNE
TUNE
ENTER
TEST
TONE
SURROUND
HTP-330.book 22 ページ ２００７年３月２７日 火曜日 午後６時８分