Filter
Top Products
Additional information11
76
En
Important information regarding
the HDMI connection
There are cases where you may not be able to
route HDMI signals through this receiver (this
depends on the HDMI equipped component
you are connecting-check with the
manufacturer for HDMI compatibility
information).
If you aren’t receiving HDMI signals properly
through this receiver (from your component),
please try the following configuration when
connecting up.
Configuration
1
Connect your HDMI-equipped component
directly to the display using an HDMI cable.
Then use the most convenient connection
(digital is recommended) for sending audio to
the receiver. See the operating instructions for
more on audio connections. Set the display
volume to minimum when using this
configuration.
iPod messages
Note
1 • If your display only has one HDMI terminal, you can only receive HDMI video from the connected component.
• Depending on the component, audio output may be limited to the number of channels available from the connected display
unit (for example audio output is reduced to 2 channels for a monitor with stereo audio limitations).
• If you want to switch the input source, you’ll have to switch functions on both the receiver and your display unit.
• Since the sound is muted on the display when using the HDMI connection, you must adjust the volume on the display every
time you switch input sources.
Symptom Cause Action
iPod/USB Error 1
(I/U ERR1)
There is a problem with the signal path
from the iPod to the receiver.
Switch off the receiver and reconnect
the iPod to the receiver. If this doesn’t
seem to work, try resetting your iPod.
iPod/USB Error 2
(I/U ERR2)
The software version being used with the
iPod needs to be updated.
Update the software being used with the
iPod (please use the latest iPod software
versions later than the iPod updater
2004-10-20).
An iPod not supported by this receiver is
connected.
Connect the iPod supported by this
receiver.
iPod/USB Error 3
(I/U ERR3)
When there is no response from the iPod. Update the iPod software to the latest
version. If this doesn’t seem to work, try
resetting your iPod.
No Track
When there are no tracks in the category
selected on the iPod.
Select a different category.
VSX-920_UCSMXCN_En.book 76 ページ ２０１０年１月２１日 木曜日 午前９時４３分