Filter
Top Products
Other connections10
68
En
1 Switch the receiver into standby and
connect
Bluetooth
ADAPTER to the
ADAPTER PORT located in the rear panel.
2 Switch on the receiver.
3Press
ADAPTER
on the remote control to
switch the receiver to ADAPTER input mode.
1
Pairing
Bluetooth
ADAPTER and
Bluetooth
wireless technology
device
“Pairing” must be done before you start
playback of Bluetooth wireless technology
content using Bluetooth ADAPTER. Make sure
to perform pairing first time you operate the
system or any time pairing data is cleared.
“Pairing” is the step necessary to register
Bluetooth wireless technology device to enable
Bluetooth communications.
2
For more details,
see also the operating instructions of your
Bluetooth wireless technology device.
1 Press TOP MENU.
2Press
ENTER
to enter
PAIRING
.
3 Select the PIN code to be used from 0000/
1234/8888 using
/
, then press ENTER.
PAIRING blinks.
Important
• You can use any of 0000/1234/8888 PIN
codes. Bluetooth wireless technology
device using any other PIN code cannot be
used with this system.
4 Switch on the
Bluetooth
wireless
technology device that you want to make
pairing, place it near the system and set it
into the pairing mode.
5 Check to see that the
Bluetooth
ADAPTER
is detected by the
Bluetooth
wireless
technology device.
When Bluetooth wireless technology device is
connected:
Bluetooth wireless technology device name
appears in the receiver display.
3
When Bluetooth wireless technology device is
not connected:
NODEVICE appears in the receiver display. In
this case, perform the connection operation
from the side of the Bluetooth wireless
technology device.
6From the
Bluetooth
wireless technology
device list, select
Bluetooth
ADAPTER and
enter the PIN code selected in the step 4.
4
Listening to Music Contents of
Bluetooth
wireless technology
device with Your System
1
Press
ADAPTER
on the remote control to
switch the receiver to
ADAPTER
input mode.
2 Perform the connection operation from
the side of the
Bluetooth
wireless technology
device to the
Bluetooth
ADAPTER.
Note
1 When the Bluetooth ADAPTER is not plugged into the ADAPTER PORT, NO ADAPTER will be displayed if ADAPTER input
mode is selected.
2 • Pairing is required when you first use Bluetooth wireless technology device and Bluetooth ADAPTER.
• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology
device.
3 The system can display alphanumeric characters only. Other characters may not be displayed correctly.
4 PIN code may in some case be referred to as PASSKEY.
VSX-920_UCSMXCN_En.book 68 ページ ２０１０年１月２１日 木曜日 午前９時４３分