Filter
Top Products
Listening to your system 05
41
En
English
Français
Deutsch
Nederlands
Italiano
Español
Setting What it does Option(s)
EQ
(Acoustic Calibration
EQ)
Switches on/off the effect of Acoustic Calibration EQ. ON
OFF
S.DELAY
(Sound Delay)
Some monitors have a slight delay when showing video, so
the soundtrack will be slightly out of sync with the picture.
By adding a bit of delay, you can adjust the sound to match
the presentation of the video.
0.0 to 9.0 (frames)
1 second = 30 frames
(NTSC)
Default: 0.0
MIDNIGHT
a
Allows you to hear effective surround sound of movies at
low volumes.
M/L OFF
MIDNIGHT
LOUDNESS
a
Used to get good bass and treble from music sources at
low volumes.
LOUDNESS
S.RTV
b
(Sound Retriever)
When audio data is removed during the WMA/MP3
c
compression process, sound quality often suffers from an
uneven sound image. The Sound Retriever feature employs
new DSP technology that helps bring CD quality sound
back to compressed 2-channel audio by restoring sound
pressure and smoothing jagged artifacts left over after
compression.
OFF
ON
DUAL MONO
d
Specifies how dual mono encoded Dolby Digital
soundtracks should be played.
CH1 –
Channel 1 is heard only
CH2 –
Channel 2 is heard only
CH1 CH2 –
Both channels heard
from front speakers
DRC
(Dynamic Range
Control)
Adjusts the level of dynamic range for movie soundtracks
optimized for Dolby Digital, DTS, Dolby Digital Plus, Dolby
TrueHD, DTS-HD and DTS-HD Master Audio (you may
need to use this feature when listening to surround sound
at low volumes).
AUTO
e
MAX
MID
OFF
LFE ATT
(LFE Attenuate)
Some Dolby Digital and DTS audio sources include ultra-
low bass tones. Set the LFE attenuator as necessary to
prevent the ultra-low bass tones from distorting the sound
from the speakers.
The LFE is not limited when set to 0 dB, which is the
recommended value. When set to –15 dB, the LFE is
limited by the respective degree. When OFF is selected, no
sound is output from the LFE channel.
0 (0 dB)
5 (–5 dB)
10 (–10 dB)
15 (–15 dB)
20 (–20 dB)
** (OFF)
SACD G.
f
(SACD Gain)
Brings out detail in SACDs by maximizing the dynamic
range (during digital processing).
0 (dB)
+6 (dB)
HDMI
(HDMI Audio)
Specifies the routing of the HDMI audio signal out of this
receiver (amp) or through to a TV or flat panel TV. When
THRU is selected, no sound is output from this receiver.
AMP
THRU
VSX-920_UCSMXCN_En.book 41 ページ ２０１０年１月２１日 木曜日 午前９時４３分