Filter
Top Products
The System Setup menu 06
51
En
English
Français
Deutsch
Nederlands
Italiano
Español
2 Select output resolution.
1
• AUTO – The resolution is selected
automatically according to the capacity of
the TV (monitor) connected by HDMI.
• PURE – The signals are output with the
same resolution as when input.
• 480p/720p/1080i/1080p – The signal is
output with the resolution specified here.
(480p means the resolution of 480p/576p)
3 When you’re finished, press RETURN.
You return to the Video Parameter menu.
Aspect
Specifies the aspect ratio when analog video
input signals are output at the HDMI OUT
terminal. Make your desired settings while
checking each setting on your display (if the
image doesn’t match your monitor type,
cropping or black bands appear).
1 Select ‘Aspect’ from the Video
parameter menu.
2 Select desired output aspect ratio.
2
• THROUGH – The input video signal is
output unchanged.
• NORMAL – Black bands will appear either
at top and bottom or on both sides.
3 When you’re finished, press RETURN.
You return to the Video Parameter menu.
Note
1 • When set to a resolution with which the TV (monitor) is not compatible, no picture is output. Also, in some cases no picture
will be output due to copyright protection signals. In this case, change the setting.
• When a display is connected by HDMI, if this is set to something other than PURE and 480i/576i analog signals are input,
480p/576p signals are output from the component output terminals.
2 If the image doesn’t match your monitor type, adjust the aspect ratio on the source component or on the monitor.
5.Video Parameter
Return
a.Video Converter
b.Resolution
c.Aspect
5c.Aspect
BD
DVD
TV/SAT
DVR/VCR
VIDEO
Return
[THROUGH]
[THROUGH]
[ NORMAL ]
[THROUGH]
NORMAL
VSX-920_UCSMXCN_En.book 51 ページ ２０１０年１月２１日 木曜日 午前９時４３分